Published August 25, 2026 at 13:16
The datasheet for this dial indicator lists three numbers, and they look like they’re about the same thing. They’re not. Accuracy ±0.018 mm. Repeatability 0.003 mm. Hysteresis ±0.004 mm. Three numbers, three different questions — and for the way a dial indicator is actually used, the middle one matters far more than the others.
What it is
A dial indicator with back plunger from Peacock, to DIN 878.
- Measuring range 0-5 mm, graduation 0.01 mm, dial 0-100
- Accuracy ±0.018 mm, repeatability 0.003 mm, max hysteresis ±0.004 mm
- Measuring force under 1.4 N
- Rotatable bezel, mounting shaft ø6.35 mm
The three numbers
Accuracy describes how close the reading is to the true value across the full five millimeters. That’s relevant if you’re reading an absolute dimension — but you almost never do that with a dial indicator. You zero against a standard or a reference part and then read the deviation.
Repeatability describes how much the reading varies when the plunger returns to the same point. At 0.003 mm, the indicator is six times better at comparing than it is at reading absolute values. And comparison is exactly the job it’s bought for: showing whether this part deviates from the last one.
Hysteresis describes the difference between approaching a point from above versus from below. ±0.004 mm is under half a graduation, but it’s there — and it disappears entirely if you get in the habit of always approaching from the same side.
The takeaway is useful when choosing an instrument: a dial indicator with an impressive accuracy figure but mediocre repeatability is worse for what you actually do with it than one with the numbers the other way round.
Why the plunger sits at the back
An ordinary dial indicator measures in the same direction the dial faces away from. That’s fine on a measuring stand, where the indicator sits vertically above the part and you look down at the dial. But in a lathe, in a fixture, or inside a machine, the measurement often has to be taken horizontally — and then the dial ends up facing straight into the machine or away from whoever needs to read it.
With the plunger routed out the back, the measuring direction is perpendicular to the dial. The indicator can then sit with the display facing the operator, while the tip works in a direction that would otherwise require reading the dial from the edge. It’s a purely geometric solution to a purely geometric problem.
The measuring force under 1.4 N and the rotatable bezel belong to the same line of thinking. Low force, because the part must not move from the measurement itself. Rotatable bezel, because the zero point needs to be set by turning the ring — not by shifting the indicator, which has just been positioned in the correct direction.
Three typical applications
- Setup in a lathe: checking runout and centering, where the measuring direction is horizontal.
- Fixtures and inspection stations: a fixed-mounted indicator, where the part is placed in and the deviation is read off.
- Tight spaces: measurements inside machines, where an ordinary indicator would have the dial facing the wrong way.
Why it pays off
A dial indicator is rarely the expensive part of a setup, but it’s what determines how small a difference you can actually see. And because the task is almost always comparison — this part against the last one, this side against the other — it’s repeatability that sets the limit on what you can detect at all.
Then there’s the practical side: an indicator that can be mounted so you can see the dial from where you’re standing gets read correctly. An indicator you have to squint at from the side gets read with parallax error — every time, in the same direction, by the same person.
Read more about the Peacock dial indicator with back plunger →